C1 => Thr; C1 => Tail - GRAUPNER mz-12 PRO Manual

C1 => Thr
Pitch
C1 Thr
C1 Tail
Tail Thr
Roll Thr
normal SEL
C1 => Tail
Pitch
C1 Thr
C1 Tail
Tail Thr
Roll Thr
normal SEL
C1 Thr
Input 0%
Output 0%
Point3 +0%
normal
C1 Thr
Input 0%
Output 0%
Point5 +30%
normal
58 / 116
3. Use one of the selection buttons to set the desired value or acti-
vate the point and then set the value.
4. Proceed in the same way with the remaining points.
5. Leave the setting menu for the selection list pushing the ESC key.
Deleting the support point step-by-step:
1. Push the ENT key to change from the selection list to the "Pitch"
setting page.
2. Move the CH 1 control stick to the point to delete.
3. Push simultaneously the left and the right selection keys.
4. Proceed in the same way with the remaining points.
5. Leave the setting menu for the selection list pushing the ESC key.
This setting only refers to the control curve for the throttle servo or
the speed controller.
Similar to the setting of the pitch curve, see above, the throttle curve
0%
can also be defined by up to 5 points.
0%
A torque compensation curve with a linear mixer ratio of 0% is uni-
formly set by default which is necessary for gyro sensors that oper-
ate in heading-lock mode, see the middle of the left representation.
0%
If you are using your gyro sensor in normal mode or the sensor can
0%
only handle normal mode, adjust the mixer as follows:
Setting the support lines step-by-step
1. Push the ENT key to change from the selection list to the "C1 =>
Tail" setting page.
2. Move the CH 1 control stick to the point 1.
3. Set point 1 to -30% with the selection keys.
4. Move the CH 1 control stick to the point 5.
5. Set point 5 to +30% with the selection keys.
6. Leave the setting menu for the selection list pushing the ESC key.
Adjust the mixer so that the helicopter does not rotate about the
vertical axis, even during long vertical ascents and descents, as a
result of differing main rotor torque in comparison to hovering.
S1002.PRO_mz12PRO_Teil2_V1sh