Table of Contents
Advertisement
FAIL-SAFE
Pos.
Position stored
hold
5 6
1 2 3 4
Delay:
0.25s
Teacher/Pupil
Free
General
Fail-
Trainer
Mixer
setting
Safe
An-
Info
nounce
display
Preparing for training mode
70 / 116
8. Use one of the selection buttons to the right to change to the
"STO" value field.
9. Now at the latest, switch on the receiver and wait for the trans-
mitter and receiver to signal correct reception.
10. All RC components placed on "Pos" and / or those which are sup-
posed to occupy a certain position during the switch-on phase of
the receiving system must be placed in the desired positions at
the same time via the respective control elements of the trans-
mitter until the ENT key is pushed to store these settings as fail-
safe settings in the receiver.
11. The successful storage of the data is shortly confirmed in the dis-
play, see representation on the left.
Otherwise check the correct radio transmission between your
transmitter and receiver systems and repeat the process.
STO
Attention
Since the fail-safe settings are stored exclusively in the receiver,
they must be renewed after a receiver change and, in the event of
a reset, be cleared in the previous receiver.
Push the ENT key to recall the selection menu from the base display.
Select the desired menu with the selection buttons, then press the
ENT button again to recall the setting list of the menu.
Push the ESC key to stop the procedure.
In this menu you can set the parameters for the teacher / pupil oper-
ation. With HoTT transmitters, both wireless and wired T/P opera-
tion are possible, always following the instructions of the pupil trans-
mitter.
Teacher transmitter
The model to be controlled by the pupil must be completely pro-
grammed, with all its functions, including trims and possible mixing
functions, into a model memory of the teacher transmitter mz-12
Pro HoTT and tested for correct control behavior and the HoTT
receiver of the respective model is "bound" to the teacher transmit-
ter.
S1002.PRO_mz12PRO_Teil2_V1sh
Advertisement
Table of Contents
