Bound Receiver (Binding) - GRAUPNER mz-12 PRO Manual

Control mode 2
Rcv output
Bind –––
Range test 99sec
RF module OFF

Bound receiver (binding)

Control mode 2
Rcv output
Bind
–––
Range test 99sec
RF module OFF
Control mode 2
Rcv output
Bind –––
Range test 99sec
RF module OFF
48 / 116
5. Push the ENT key.
6. Proceed appropriately with the remaining combinations.
7. Push the ESC key to come back to the output display.
Notes
• Before leaving the setting menu, check all settings for uninten-
tional servo / output combinations.
• If the warning message "Can't receive any data" is displayed,
there is no active telemetry connection between transmitter
and receiver. Possibly the RF module and / or the receiving sys-
tem must be switched on or the receiver must be bound as
described below.
To establish a connection with the transmitter, Graupner HoTT
receivers must first be "bound" to at least one model memory in "its"
Graupner HoTT transmitter. This process is generally called "bind-
ing" and it can be repeated all the times it is needed.
By default, the binding mode is "model" specific. As long as no
receiver is bound to the model memory in question, this default can
be changed to "global", see below under "Binding type".
Binding step-by-step
1. Switch on the power supply of the transmitter and the receiver to
bind.
2. Ensure that there is a sufficient distance between the antennas
of the two devices so that there is no overlapping of the return
channel.
3. Eventually change to the "Tx setting" menu of the transmitter
mz-12 Pro HoTT and there go to the line "Rx bind".
4. Bring the receiver in the binding mode according to the instruc-
tions.
5. Press the ENT button of the transmitter for about three seconds.
6. In the transmitter display, "BIND" is displayed rhythmically instead
of the three hyphens.
If the binding process succeeds, the identification of the now bound
receiver appears instead of the rhythmically flashing "BIND". Other-
wise change the positioning of the devices and repeat the process.
Note
It is important to make sure that the receiver power supply is cor-
rect. If the power supply is too low, the receiver LEDs will react, as
described in the related receiver manual, in response to your bind-
ing attempt, but the HoTT synchronization will not be performed.
S1002.PRO_mz12PRO_Teil2_V1sh