Table of Contents
Advertisement
1
–––
2
–––
3
–––
4
–––
5
–––
Announce file
Info display
Free
General
Fail-
Trainer
Mixer
setting
Safe
An-
Info
nounce
display
RFID
FA-AA-AA-A9-9F
1.234
Firmware version
Default setting
RFID
Firmware version
74 / 116
Programming step-by-step
1. Use the selection keys to select the desired line.
2. Assign the desired switch in the line upon the switch symbol "
".
3. Use the right selection key to switch to the right-hand column.
4. Push the ENT key.
5. Use the selection keys to select the desired announce.
6. Press the ENT key to complete the operation.
7. Proceed appropriately with the remaining lines.
8. Leave the menu pushing the ESC key.
Push the ENT key to recall the selection menu from the base display.
Select the desired menu with the selection buttons, then press the
ENT button again to recall the setting list of the menu.
Push the ESC key to stop the procedure.
In this menu, transmitter-specific information is displayed and it is
possible to reset the transmitter to the delivery state.
=>
The RFID of the transmitter is displayed in this line. This ID is specific
for each transmitter, is only issued once per transmitter, and cannot
be changed.
The current version number of the transmitter software is displayed
in this line.
The version number could be required for service inquiries.
S1002.PRO_mz12PRO_Teil2_V1sh
Advertisement
Table of Contents
