Telemetry - GRAUPNER mz-12 PRO Manual

Telemetry

RX FAIL SAFE V6.37
OUTPUT CH: 01
INPUT CH: 01
MODE : HOLD
F.S.Pos. : 1500µsec
DELAY : 0.75sec
FAIL SAFE ALL: NO
POSITION : 1500µsec
76 / 116
Receiver settings and the displays and settings of the connected
telemetry sensors can be retrieved and programmed in real time in
the "Telemetry" menu.
The connection to the receiver is maintained by the feedback chan-
nel of the HoTT receiver. The exchange of telemetry data between
transmitter and receiver takes normally place only after each four RC
data-packs. Therefore also the reaction to control buttons or setting
changes has normally within a telemetry connection a delay. This
does not constitute an error.
Attention
• The model or sensors may only be programmed when the model
is on the ground. Only perform settings when the motor is
turned off or the drive battery is disconnected.
• All settings that have been made using the "Telemetry" menu
(such as fail safe, reversal of the direction of servo rotation,
servo travel, mixer and curve settings, etc.) are only saved in the
receiver and are therefore transferred to other models when
the receiver is switched. You therefore need to reinitialize your
HoTT receiver if you want to use your receiver in another model.
The menus grouped under the definition "Telemetry" can be recalled
at any time by pushing the VIEW key of the right four-way keys from
the base display so as from almost every other menu positions.
Basic operation
Basically the "Telemetry" menu corresponds to the other menus of
the mz-12 Pro HoTT transmitter: The few deviations are described
below:
• Analogously to the directional arrow in the upper right of the dis-
play ( ) the right or left selection key is used to switch between
the individual pages of the "telemetry" menu.
If there is only one angled bracket, the first or last page is active
in the menu. You can then only change pages in the displayed
direction.
• Menu lines in which parameters can be changed are indicated by
a preceding angle bracket ( ). Pressing the upper or lower selec-
tion button moves this " " pointer one line down or up.
Lines which cannot be jumped cannot be changed.
S1002.PRO_mz12PRO_Teil2_V1sh