Available Accessories; Maintenance; Repairs - FAAC 615 Instruction Manual

9 AVAILABLE ACCESSORIES

SKIRT KIT (fig.14)
The skirt kit increases visibility of the beam.
It is available in lengths from 2 m to 3 m.
If a skirt kit is installed, the balancing spring must be
adapted.
FORK SUPPORT (fig.15)
The fork has two functions:
- it prevents the beam, when closed, from bending or splitting
if its end is stressed by extraneous forces.
- it allows the beam to rest when closed and thus prevents
the profile bending downward.
POSITIONING THE FORK SUPPORT FOUNDATION PLATE
Dimensions are in mm.
To position the foundation plate of the fork support, refer to
fig.16 where:
P1 = barrier foundation plate
P2 = fork support foundation plate
L = beam length (in mm)
A = L - 195 (in mm)
ARTICULATION KIT (fig.17)
The articulation kit makes it possible to articulate a rigid
beam to a maximum ceiling height of 3 m. (see specific
instructions).
If the articulated kit is installed, the balancing
spring must be adapted.
END FOOT (fig.18)
The end foot allows the beam to rest when closed and thus
prevents the profile bending downward.
fig. 14
If a foot is installed, the balancing spring must be
readjusted.

10 MAINTENANCE

Whenever doing maintenance, always check correct
settings of the by-pass screws, system balancing, and
efficiency of safety devices. The automated system does
not require any type of oil topping-up.
fig. 15

11 REPAIRS

For any repairs, contact FAAC's authorised Repair Centres.
fig. 16
8
fig. 17
fig. 18