Gree GVA24AL-K3NNC7A/I Service Manual page 79

Step
14.Remove propeller housing, centrifugal blade and
motor
Remove 3 screws used for fixing the press
a
plate of propeller housing and then remove
the press plate of propeller housing;
b
Rotate the guide loop to a certain position
along the clockwise direction, and then
remove the guide loop;
c
Remove 9 screws used for fixing the
propeller housing, and then remove the
propeller housing;
Use wrench to twist off the nuts used for
d
fixing the centrifugal chiller and then pull the
centrifugal blade outwards;
e Remove the centrifugal blade;
Remove 4 nuts used for fixing the motor and
f
2 screws used for fixing the wire-pressing
plate, and the remove the motor.
15.Remove chassis
After 9 screws are removed, pull the chassis
downwards to remove it.
76
Procedure
Propeller housing
Guide loop
Centrifugal blade
Press plate of propeller housing
Motor
Wire-pressing plate
Chassis
Installation and Maintenance
Service Manual