Gree GVA24AL-K3NNC7A/I Service Manual page 26

Service Manual
8
button
Under simple swing mode, pres this button can turn on ("
the left&right swing function.
When the unit is turned off by remote controller, press "▲" button and "
and fixed-angle swing mode.
Under fixed-angle swing mode, press this button and then left&right swing status will circulate as shown in the right figure:
This remote controller is the general type remote controller. When remote controller receives the signal of
status is same as "
9
button
Under simple swing mode, pres this button can turn on ("
up&down swing function.
When the unit is turned off by remote controller, press "▲" button and "
fixed-angle swing mode.
the up&down swing status will circulate as shown in the right figure:
10
SLEEP button
Under COOL, or HEAT mode, press this button to start up sleep function. "
button again to cancel sleep function and "
turned off, the Sleep function is canceled. In this mode, the time of time can be adjusted. Under Fan DRY and Auto modes,
this function is not available.
11
WiFi button
Press " WiFi " button to turn on or turn off WiFi function. When WiFi function is turned on, the " WiFi " icon will be displayed on
remote controller; Under status of remote controller off, press "MODE" and " WiFi " buttons simultaneously for 1s,WiFi module
will restore to factory default setting.
This function is only available for some models.
12
X-FAN/E-HEATER button
Pressing this button in COOL or DRY mode, the icon "
minutes in order to dry the indoor unit even though you have turned off the unit. After energization, X-FAN OFF is
defaulted.X-FAN is not available in AUTO, FAN or HEAT mode.
unit will be blowed after the unit is stopped to avoid mould.
Having set X FAN function on: After turning off the unit by pressing ON/OFF
about a few minutes. at low speed.
Having set X FAN function off: After turning off the unit by pressing ON/OFF button, the complete unit will be off directly.
Only under cooling mode and dry mode, press this button can turn on (characters
(characters of "X-FAN" are not displayed)
Under heating mode, press this button and the E-HEATER status will changed circularly as below:
Technical Information
" " on the remote controller will flash twice.
no display
" ; when remote controller receives "
" " on the remote controller will flash twice. Under fixed-angle swing mode, press this button and
no display
" icon will disappear.After powered on, Sleep Off is defaulted. After the unit is
In this period, press X-FAN button to stop indoor fan directly.
X-FAN function.
Auto E-HEATER (no display)
E-HEATER OFF
( is displayed)
" icon is displayed) or turn off ("
" button can switch between single swing mode
" , swing status is same as left&right swing OFF.
" icon is displayed) lor turn off ("
" button can switch between single swing mode and
" icon is displayed on remote controller. Press this
" is displayed and the indoor fan will continue operation for a few
This function indicates that moisture on evaporator of indoor
button indoor fan will continue running for
E-HEATER ON
( is displayed)
" icon is not displayed)
"
" icon is not displayed) the
of "X-FAN" are displayed) or turn off
" , swing
23