Error Codes - Henny Penny OFE-322 Technical Manual

1-4. ERROR CODES

DISPLAY
"E-4"
Control board
overheating
"E-5"
Shortening
overheating
"E-6A"
Temperature
probe open
"E-6B"
Temperature
probe shorted
"E-10"
High limit
"E-15"
Drain switch
failure
"E-41",
Programming
"E-46"
failure
203
In the event of a control system failure, the digital display shows
an error message. These messages are coded: "E-4", "E-5", "E-
6A", "E-6B", "E-10", "E-15", "E-20", "E-31", "E-41", "E-46",
and "E-92". A constant tone is heard when an error code is
displayed, and to silence this tone, press any button.
CAUSE
Turn switch to OFF position, then turn switch back to ON;
if display shows "E-4", the control board is getting too hot;
check the louvers on each side of the unit for obstructions
Turn switch to OFF position, then turn switch back to ON;
if display shows "E-5", the heating circuits and temperature
probe should be checked
Turn switch to OFF position, then turn switch back to ON;
if display shows "E-6A" the temperature probe should be
checked
Turn switch to OFF position, then turn switch back to ON;
if display shows "E-6B" the temperature probe should be
checked to replace, per Temperature Probe Replacement
Section
Reset the high limit by manually pushing up on the red
reset button; if high limit does not reset, high limit must be
replaced per High Limit Temperature Control Section
Close drain, using the drain valve handle; if display still
shows "E-15", check the drain microswitch per Drain
Microswitch Section
Turn switch to OFF, then back to ON. If display shows any
of the error codes, try to reinitialize the control (Special
Program Mode Section of Operator's Manual). If error
Code persists, replace the control panel per Complete
Control Panel Replacement Section
Model OFE/OFG-321,322,323,324
PANEL BOARD CORRECTION
1-5