Henny Penny OFE-322 Technical Manual page 35

2-22. AUTOLIFT ACTUATOR (MOTOR)
REPLACEMENT(if applicable) (Continued)
2-26
4. Remove rear cover.
CUT WIRES
HERE
5. Disconnect actuator connector and cut the wires from the other
half of the connector, as shown at left. The new actuator wires
do not have a connector on them and must be connected
directly to the wires on the unit.
6. Using a 3/8 socket, remove the 3 nuts securing the bottom of
the actuator bracket.
7. Remove trim strip from front of shroud.
8. Using a 15T torx driver, remove the 4 torx screws from the pair
of actuators.
Model OFE/OFG-321,322,323,324
606