Table of Contents
Advertisement
W1766
⁄
HP Power Feeder
1
2
The machine must be properly set up before it is
safe to operate. DO NOT connect this machine to the
power source until instructed to do so in the "Test
Run" portion of this manual.
220V Operation
The Model W1766 is wired for 220V operation. We
recommend connecting this machine to a dedicated
circuit with a verified ground, using the circuit size below
as a minimum. Never replace a circuit breaker with one of
higher amperage without consulting a qualified electrician
to ensure compliance with wiring codes.
This machine must be grounded! The electrical cord
supplied with this machine comes with a grounding pin. If
your outlet does not accommodate a ground pin, have it
replaced by a qualified electrician.
If you are unsure about the wiring codes in your area
or you plan to connect your machine to a shared
circuit, you may create a fire or circuit overload
hazard—consult a qualified electrician to reduce this
risk.
Extension Cords
We do not recommend using an extension cord; however,
if you have no alternative, use the following guidelines:
•
Use a cord rated for Standard Service (S).
•
Do not use an extension cord longer than 50 feet.
•
Ensure that the cord has a ground wire and pin.
•
Use the gauge size listed below as a minimum.
Electrical Specifications
Operating Voltage
220V Operation
ELECTRICAL
Amp Draw
Min. Circuit Size
5.5 Amps
6-15 P
Figure 2. 6-15 plug and receptacle.
DO NOT work on your electrical system
if you are unsure about electrical
codes and wiring! Seek assistance from
a qualified electrician. Ignoring this
warning can cause electrocution, fire,
or machine damage.
Plug/Receptacle
15A
NEMA 6-15
-9-
6-15 R
Extension Cord
14 Gauge
Advertisement
Table of Contents
