Initial Configuration Using The Cisco Cli—Manual Configuration - Cisco CISCO871-K9 - 871 Integrated Services Router Hardware Installation Manual

Initial Configuration Using the Cisco CLI—Manual Configuration
Respond to the following prompts. Enter 2 to save the initial configuration.
Step 11
[0] Go to the IOS command prompt without saving this config.
[1] Return back to the setup without saving this config.
[2] Save this configuration to nvram and exit.
Enter your selection [2]: 2
Building configuration...
Use the enabled mode 'configure' command to modify this configuration.
Press RETURN to get started! RETURN
The user prompt is displayed.
Router>
Verify the initial configuration. See the
Step 12
procedures.
Initial Configuration Using the Cisco CLI—Manual
Configuration
This section shows how to display a command-line interface (CLI) prompt for configuration using the
CLI, and it directs you to documentation for the CLI configuration.
You can use the CLI if the following messages appear at the end of the startup sequence:
--- System Configuration Dialog ---
At any point you may enter a question mark '?' for help.
Use ctrl-c to abort configuration dialog at any prompt.
Default settings are in square brackets '[]'.
Would you like to enter the initial configuration dialog? [yes/no]:
If these messages do not appear, SDM and a default configuration file were installed on the router. To
use SDM to configure the router, see the
Be sure to save your configuration changes occasionally so that they are not lost during resets, power
Note
cycles, or power outages. Use the copy running-config startup-config command at the privileged
EXEC mode prompt (Router#) to save the configuration to NVRAM.
To proceed with manual configuration using the CLI, enter no when the power-up messages end.
Step 1
Would you like to enter the initial configuration dialog? [yes/no]: no
Press Return to terminate autoinstall and continue with manual configuration.
Step 2
Would you like to terminate autoinstall? [yes] Return
Several messages appear, ending with a line similar to the following:
Copyright (c) 1986-2004 by Cisco Systems, Inc.
Compiled <date> <time> by <person>
Cisco 850 Series and Cisco 870 Series Access Routers Hardware Installation Guide
5-4
"Verifying the Initial Configuration"
"Initial Configuration Using Cisco SDM"
Chapter 5 Initial Configuration
section for verification
section.
OL-5331-01