Table of Contents
Advertisement
HH2S-9XL10 Handheld Remote
1.2 HH2S-9XL10 Battery Warning and Shutdown
HH2S-9XL10 will alert the user if the remaining battery life is getting low or is too low for normal
operation.
LOW BATTERY
BATTERY LED flashes once per second indicating a LOW BATTERY (2.2V or less)
situation is present. Two fresh AAA batteries should be replaced as soon as possible.
The LED will continue to flash at one second intervals until the batteries are changed, or
until the voltage level drops to 2.0V and Auto-Shutdown occurs.
Note: The receiver LED will quickly flash three times, once per minute when handheld
low battery is indicated.
AUTO-SHUTDOWN
At 2.0V, the BATTERY LED flashes briefly for approximately 1.25 seconds before the
handheld remote automatically shuts down.
Two fresh AAA batteries must be installed before the handheld can be used again.
Low Battery
Flash 10/s
Figure 5. HH2S-9XL10 Remote Low Battery Warning and Auto-Shutdown
1.3 System Startup
The following assumes that power is applied to the Warrior 32 MU-9X15 receiver.
1. Press the handheld STOP button (B1).
2. Wait while the LEDs cycle and then the RX/TX begins to flash.
3. Press the Horn/Start button (B2). This energizes the MLC relays in the receiver.
The handheld is ready for normal functional operation.
.
Shutdown
One Flash! Handheld
can't be used until the
depleted batteries are
replaced.
B1
Figure 6. System Startup
3
2
2017 Cervis, Inc
3
Advertisement
Table of Contents
