Associating A Handheld With A Receiver; Two Unlock Association Methods; Unlock Association Method 1; Figure 7. Receiver Sw01 Dip Switch 8 (Associate Lock) - Cervis Warrior 32 HH2S-9XL10 Manual

2.0 Associating a Handheld with a Receiver

Warrior 32 system handhelds are associated to the receiver before the system is shipped and
the Associate process is locked by MU-9X15 receiver SW01 DIP switch 8 (Figure 7) being 0
(OFF). The receiver will only communicate with handhelds to which it is associated. Other
Warrior 32 handhelds can be associated to the receiver when necessary as additional spares or
to replace damaged handhelds, but the receiver association ability must be first unlocked.

2.1 Two Unlock Association Methods

2.1.1 Unlock Association Method 1

Method 1 is by manually changing the position of receiver SW01 DIP switch 8. To unlock
association, the receiver enclosure must be opened and SW01 DIP Switch 8 (Associate Lock)
must be changed from its default position 0 (OFF) to 1 (ON). Unlocking the receiver DIP switch
will allow association until DIP switch 8 is changed back to the 0 (OFF or LOCKED) position.
SW01 Receiver
Example

Figure 7. Receiver SW01 DIP Switch 8 (Associate Lock)

Associating a Handheld Using the DIP Switch Unlock Option
This process will unlock association of the receiver allowing the user to associate handhelds to
the receiver until the DIP switch is set back to the locked position.
1. Set machine unit SW01 DIP Switch 8 ON (Figure 7).
2. If machine unit is Off (powered down), the Horn/Light relay will activate when it is
powered. If machine unit is On (powered), the Horn/Light relay will immediately activate.
3. Go to Heading 2.2.
U101.1.0
4
MODE
*Applies only to HH, only in MODE 00 and 01
**Applies only to HH, only in MODE 00 and 01, only if SW4 = 1
It is not recommended to leave receivers in an UNLOCKED
state. Move DIP switch 8 to the "0" (OFF) position once
association is complete.
1
0
ASOC
LOCK