Viewing Trip Cycle Procedures - Zurich ZR11 Owner's Manual

4. Start and warm the engine to normal
operating temperature. Turn on the
headlights. Press the ENTER
to continue.
An "instructional" message shows
on the Code Reader's display.
5. Press the accelerator pedal to raise
engine speed to 2000 RPM, and
maintain the engine speed.
When engine speed is within the
required range, the alternator test
begins. A progress screen shows
the Engine RPM and "countdown"
timer.
When the "countdown" timer expires,
an "instructional" message shows
on the Code Reader's display.
6. Turn the vehicle's headlights off, and
return the engine to idle speed.
A "One moment please..." message
displays while the test results are
retrieved.
7. When the alternator check is complete,
a results screen shows charging system
voltage and indicates whether or not the
charging system is within acceptable
limits. The System Status LEDs provide
a PASS/FAIL indication, as follows:
Green = System within limits
Yellow = Over charging or under charging
Red = Excessive over charging or under charging
If the alternator voltage is less than 9 V, the red, yellow and
green SYSTEM STATUS LEDs will flash on and off.
8. Press the M button to return to the Main Menu.

VIEWING TRIP CYCLE PROCEDURES

A Trip Cycle for a Monitor requires that the vehicle is driven in such a
way that all the required "Enabling Criteria" for the Monitor to run and
complete its diagnostic testing are met. You can use the Code Reader
to view the Trip Cycle procedures for a selected Monitor.
1. While linked to a vehicle, press the M
button.
The Main Menu displays.
Additional Tests
VIEWING TRIP CYCLE PROCEDURES
button
71