Battery Replacement - Zurich ZR11 Owner's Manual

On some Asian and European vehicles the DLC is located
behind the "ashtray" (the ashtray must be removed to
access it) or on the far left corner of the dash. If the DLC
cannot be located, consult the vehicle's service manual for
the location.

BATTERY REPLACEMENT

Replace batteries when the battery symbol
and/or the 3 LEDS are all lit and no other data is visible on screen.
1. Locate the battery cover on the back of the Code Reader.
2. Slide the battery cover off (use your fingers).
3. Replace batteries with three AA-size batteries (for longer life, use
Alkaline-type batteries).
4. Reinstall the battery cover on the back of the Code Reader.
Adjustments After Battery Installation
The first time the Code Reader is turned on, you must select the desired
display language (English, French or Spanish) and unit of measurement
(Standard or metric) as follows:
1. Press the POWER/LINK
to turn the Code Reader "ON."
The Select Language screen dis-
plays.
2. Use the UP
as necessary, to highlight the desired
display language.
3. When the desired display language is
selected, press the ENTER
to confirm your selection.
The Select Unit screen displays.
4. Use the UP
as necessary, to highlight the desired
unit of measurement.
5. When the desired unit of measurement
is selected, press the ENTER
button to confirm your selection.
The
Version screen displays.
After the initial language and unit of measurement selections
are performed, these, as well as other settings, can be
changed as desired. Proceed to "ADJUSTMENTS AND
SETTINGS" on page 76 for further instructions.
and DOWN
and DOWN
Code Reader's
About the Code Reader
BATTERY REPLACEMENT
is visible on display
button
buttons,
button
buttons,
Firmware
3