Customizing Live Data (Pids) - Zurich ZR11 Owner's Manual

CUSTOMIZING LIVE DATA (PIDs)

This feature lets you customize the Code Reader display to show only
those PIDs that are of interest at the current time. You can customize
the Live Data display by placing the Code Reader in "Custom Live Data"
mode and selecting only the PIDs that you wish to display. To customize
the Live Data display, proceed as follows:
1. With the Code Reader in Live Data
mode (see VIEWING LIVE DATA on
page 53), press and hold the LD button
until the Live Data Menu displays, then
release the LD button.
2. Use the UP
buttons, as necessary, to highlight
Custom Live Data, then press the
ENTER
If the Code Reader fails to establish
communication with the vehicle, a
"Communication Error" message is
shown on the Code Reader's display.
- Ensure your vehicle is OBD2
compliant.
COVERED on page 2 for vehicle
compliance verification information.
- Verify the connection at the DLC,
and verify the ignition is ON.
- Turn the ignition OFF, wait 5
seconds, then back ON to reset
the computer.
- Press the POWER/LINK
button to continue.
If Live Data is not supported by the
vehicle under test, an advisory
message
SYSTEM
return to the System Menu. Live
Data is not available for your vehicle.
If custom Live Data was previously
selected, the Select PIDs to Use
screen displays.
- To use the existing custom Live data selections, use the UP
existing PIDs, then press the ENTER
step 5.
and DOWN
button.
See
displays. Press
MENU
and DOWN buttons, as necessary, to highlight Use
Live Data Mode
CUSTOMIZING LIVE DATA (PIDs)
VEHICLES
the
button to
button. Proceed to
55