Description Display Modes
''OFF'' Mode
When the rocker switch is in the ''OFF'' position, the display shows the model of
the humidifier and the program version number.
Scroll Mode
When the rocker switch is in the auto position, the display scrolls the following information every 6 seconds:
Display
HUMIDITY
45.2%
DEMAND
92%
OUTPUT
100%
WATR LVL
92%
WATR TMP
65C
When the following conditions occur, the diagnostic messages override the scrolling information:
Display
AIR FLOW
OPEN
HI LIMIT
CUT-OUT
DRAIN
CYCLE
OVER
HEATED
PROBE
DEFECTED
Description
Percent of relative humidity
Percent of demand
Percent of output of the humidifier
Water level in percent to the objective
Water temperature in Celsius
Description
Air flow proof
Hi limit cut out
Drain cycle
Overheated
Defective probe
SKE-XL BACnet Steam Humidifier
Installation Instructions and User Manual
Only on modulating units (suffix M).
Control signal input response from
0-100%
Capacity output of the humidifier.
100% correspond to optimum water level in
evaporation chamber.
Water temperature inside the evaporation
chamber.
Comment
The airflow is not detected by the air pressure switch
(modulating unit only).
Humidity level has exceeded the set point on the high limit
humidistat.
The unit is in the automatic drain mode
The temperature inside the container has exceeded the
boiling temperature. The humidifier has automatically shut
off.
The water level sensor is not operational. The humidifier has
automatically shut off
23
Operation Display
NEP 3.6
SK390M
(Illus. 24)
Comment
List of Alarms