Pioneer DVR-LX60D Operating Instructions Manual page 110

The Initial Setup menu
15
Setting
Component Video
Out
•
For Component Video Out to be effective, the AV1 Out setting (see below) must be set to something other than
RGB.
•
If your TV is incompatible with progressive scan video and you select Progressive, you will not be able to see any
picture at all. In this case, press  OPEN/CLOSE while holding down the  (Stop) button on the front panel to
switch to Interlace (this also switches Screen Resolution on page 116 to the default setting).
•
When the HDMI signal is output, no video is output from the COMPONENT VIDEO OUT.
AV1 Out
•
If you choose a setting that is incompatible with your TV you may not be able to see any picture at all. In this case
either switch off and reconnect using the supplied video cable, or reset the recorder (see Resetting the recorder on
page 136).
•
The Component Video Out setting (see above) has no effect when AV1 Out is set to RGB.
•
When the HDMI signal is output, the AV1 Out outputs the composite video signal even when it is set to RGB.
AV2/L1 In
NTSC on PAL TV
Many recent PAL TVs are compatible with NTSC input and so this setting can be switched off. Check the operating
instructions that came with your TV. See also About NTSC on PAL TV on page 119 for related information.
Audio In
NICAM Select
Analog Tuner Level Normal •
110
En
Options Explanation
Interlace • Select if your monitor/TV is not compatible with
progressive-scan video.
Progressive
Select if your monitor/TV is progressive-scan
compatible. Check the operating instructions that
came with your monitor/TV if you're not sure.
Video • Sets the AV1 (RGB)-TV SCART output to standard
composite video (compatible with all TVs).
S-Video Sets the AV1 (RGB)-TV SCART output to S-video.
Recommended if you are using a long SCART cable.
RGB Sets the AV1 (RGB)-TV SCART output to RGB. Good
quality but check your TV for compatibility. Note that
on this setting signals from the built-in tuner and
from external inputs is not output when the recorder
is in TV mode.
Video • Sets the AV2 (INPUT 1) SCART input to standard
composite video.
S-Video Sets the AV2 (INPUT 1) SCART input to S-video.
RGB Sets the AV2 (INPUT 1) SCART input to RGB.
On •
NTSC discs will play correctly on PAL-only TVs.
Off
Use if your TV is already NTSC-compatible.
NICAM • Record the NICAM audio in a NICAM broadcast.
Regular Audio Record the non-NICAM audio in a NICAM broadcast.
(You can still switch the audio to record using the
AUDIO button before recording.)
Standard setting.
Compression
Use if the audio level from the built-in tuner is
excessive, causing distortion.