Pioneer DVR-LX60D Operating Instructions Manual page 109

The Initial Setup menu
Setting
Manual CH Setting
Channel Swapping
G-Code CH Setting
Video In/Out
Input Colour
System
• Input Colour System cannot be set when the recorder is in D.TV mode.
• See also About the input colour system on page 119 for more information on this setting.
Options Explanation
Next Screen Proceed to the next screen if you need to adjust any
of the settings made by auto tuning. Select your
country, then proceed to the manual channel setting
screen:
• Change channel presets using the
• To skip the displayed channel (because there is no
station assigned to that channel), change the Skip
setting to On.
• Set the CH SYSTEM setting to match the channel
system of your country or region.
• Set the CHANNEL setting to the channel you want
to assign to the current channel preset.
• To manually fine tune the channel, change the AFT
setting to Off then adjust the Level setting.
• Set the Sound System setting to match the sound
system of your region.
• The Name field allows you to input a name of up to
five characters for the current channel preset.
Next Screen Proceed to the next screen to swap channel
assignments of different presets so that you can
group together presets that naturally go together.
Select two presets to swap then press ENTER.
Next Screen Proceed to the next screen to assign channel
numbers to the guide channels as necessary. Look in
your TV guide to see which channel numbers should
be assigned to which guide channels. Press ENTER
when your done to leave this screen.
Next Screen
Proceed to the next screen to set the input colour
system for the external input and the built-in TV
tuner. Use the
to change the preset or external input. On the default
Auto setting the recorder can generally correctly
detect whether the input signal is PAL, SECAM, 3.58
NTSC or PAL-60, but in some cases you may have to
set it manually if the picture is displayed incorrectly.
Smart Jog or INPUT SELECT buttons
15
Smart Jog
.
109
En