Troubleshooting Information On Windows 95/98 - Fujitsu DESKPOWER 5000 Series User Manual

The power is not turned on or the Power lamp on the front panel
does not light up.
Is the power cable plugged in?
Data cannot be read from the CD-ROM drive.
Check the following:
- Has the CD-ROM been placed properly at the center of the tray? Place the CD-ROM on the
tray again with the label side facing upward.
- Has the CD-ROM been placed upside down on the tray? Place the CD-ROM on the tray in
the proper manner with the label side facing upward.
- Is the CD-ROM dirty or wet? Clean the CD-ROM with a soft dry cloth (moving from the center
to the periphery).
- Is the CD-ROM damaged? Replace the CD-ROM.
- Does the CD-ROM conform to the required standard? Use a correct CD-ROM.
Characters entered using the keyboard are not displayed.
Is the keyboard connected correctly? See "2 Connection" in Chapter 1, "Installation" to
connect the display cable correctly.
The mouse cursor does not move.
Is the mouse connected correctly? See "2 Connection" in Chapter 1, "Installation" to connect
the display cable correctly.

Troubleshooting information on Windows 95/98

○ ○ ○ ○ ○ ○ ○ ○ ○
The entire Windows 95/98 programs are frozen during the execution of an
application.
First press the Ctrl + alt + Delete keys to end the application. If the application cannot be
terminated, press the Ctrl + Alt + Delete key twice to reboot the computer. If the computer
cannot be rebooted, press the Power switch to turn off the power, then reboot a few minutes
later. After the computer is rebooted, from the Start menu, select Program - Accessories -
System tools, then click on Scan disk.
If no error is detected by the scan disk utility, continue operation. If an error is detected,
respond in accordance with the messages displayed.However, the error might happen again
after it has been corrected. If the error recurs, attempt to reinstall Windows 95/98 or
applications.
Point
The current operation data by an application is not saved if the application is terminated using
the Ctrl + Alt + Delete keys or the computer is reset.
5
89