Fujitsu DESKPOWER 5000 Series User Manual page 87

Boot Time Diagnostic Screen
This item sets whether to display the self diagnostic (POST) screen at boot or reboot.
- Disabled (Initial value)
The FUJITSU logo is displayed at boot or reboot.
- Enabled
The self diagnostic (POST) screen is displayed at boot or reboot.
Point
To confirm BIOS messages from an extension card, select [Enabled].
Preboot Execution Environment
This item sets whether to preboot from the network server.
- Disabled
Boots the computer from its hard disk drive, CD-ROM drive, or floppy disk drive.
- Enabled (Initial value)
Starts the computer from a network server. If the computer is rebooted after this item is set to
[Enabled], "PXE" is added to "Boot Device Priority."
Point
To boot from the network server, an installation server system conforming to Network PC
System Design Guidelines Version 1.0b is required.
Delay Time for ATA/ATAPI Drive
This item sets the wait time until the computer automatically identifies the ATA/ATAPI drive.
- None
The computer boots automatic identification as soon as it launches.
- 3, 5, 10, 15, 30 seconds (Initial value: 3 seconds)
The computer boots automatic identification after a preset time.
Point
If the computer does not identify the connected ATA or ATAPI drive properly, extend the
preset time.
4
77