Supplement; Peripheral Devices And Cables; Note On Using The Display; Note On Using An Analog Liquid Crystal Display - Fujitsu DESKPOWER 5000 Series User Manual

Supplement

Peripheral devices and cables

○ ○ ○ ○ ○ ○ ○
When peripheral devices or cables are connected to the PC, use Fujitsu-supplied devices and
cables, as some non-Fujitsu devices and cables may not be connectable.

Note on using the display

○ ○ ○ ○ ○ ○ ○
The vertical and horizontal lines displayed by a CAD application may appear different in width
depending on the setting of the resolution of the display used. Adjust the setting correctly
before using.

Note on using an analog liquid crystal display

○ ○ ○ ○ ○ ○ ○
• Connect a digital liquid crystal display to the PC and turn on the display power, then turn
onthe PC power.
• If the digital liquid crystal display is connected to the PC or turned on after the PC power is
turned on, the display screen may remain blank.
• The PC does not support to connect both of analog display and digital simultaneously. Use
either of them.
• When digital display is used, set the resolution to up to 1024 X 768. The PC does not support
the resolution more than this value.
Display disturbed when the screen mode is changed
The screen display may experiance disturbance temporariry or horizontal lines may appear on
the screen when the screen display begins or ends or when the display mode changes, such
as when Windows starts or ends or when the normal display mode is restored from the power
save mode. These disturbances are not considered faults.

Digital display output

○ ○ ○ ○ ○ ○ ○
Digital display output is not compatible with a monitor exceeding XGA (1024X 768 pixels)
resolution. Use an XGA or low-resolution monitor.
107