Fujitsu DESKPOWER 5000 Series User Manual page 64

Serial/Parallel Port Configurations
This item sets the I/O address of the serial and parallel ports and has submenus.
Move the cursor to this item and press the Enter key to display a submenu as shown below.
F1
ESCExit
– Serial Port 1
This item sets the I/O port address and interrupt request of serial port 1.
- Disabled
The serial port is disabled and resources are freed.
- Enabled (Initial value)
Set the I/O port address and the interrupt request of the serial port.
- Auto
The personal computer automatically assigns an I/O port address and an interrupt
request.
Point
- When 'Serial Port 1' is [Disabled], the port is not transparent to devices controlled by the
Windows 95/98 APM device manager.
- To disable the serial port on Windows 98 ACPI and Windows 2000, use the Windows 98
ACPI device manager.
I/O Address
This item appears when 'Serial Port 1' is [Enabled]. Set the I/O address of serial port 1.
- 3F8 to 3FF, 2F8 to 2FF,3E8 to 3EF, and 2E8 to 2EF (Initial value: 3F8 to 3FF)
Interrupt
This item appears when 'Serial Port 1' is [Enabled]. Set the interrupt request of serial port 1.
- IRQ3, IRQ4, IRQ10, IRQ11 (Initial value: IRQ4)
54
PhoenixBIOS Setup Utility
Main Advanced Security
Serial/Parallel Port Configurations
Serial port 1:
I/O address:
Interrupt:
Serial port 2:
Mode:
Parallel port:
Mode:
I/O address:
Interrupt:
↑↓
Help Select Item
←→
Select Menu
Power Boot
[Enabled]
[3F8-3FF]
[IRQ 4]
[Disabled]
[Serial Connector]
[Enabled]
[Bi-directional]
[378-37F]
[IRQ 7]
-/Space Change Value
Select :Sub-Menu F10Save and Exit
Enter
Info Exit
Item Specific Help
[Enabled]
The port is enabled
with user
configuration.
[Auto]
A Plug & Play OS an
ACPI OS will
configure the port.
[Disabled]
The port is
disabled.
F9 Setup Defaults