Setup Screens - Graco 24T918 Instruction Manual

Setup Screens

NOTE: It is important to set all settings in the System
screens correctly to ensure optimal system perfor-
mance.
Password
If the password is not "0000", the password must be
entered to access the setup screens.
System 1
A PLC can be used to control or monitor the system.
See PLC Connection on page 27 for instructions.
System 2
Use this screen to enable the installed channels and
specify the type of applicator RTD type used. See
Select ADM Settings on page 24.
333347F
System 3
Enable Diagnostic Screen: Choose whether to hide
the Diagnostic screen.
Lock Run Screens: Disable setpoint changes on the
run (operation) screens. If the setup screens are pass-
word protected, the setpoints cannot be changed with-
out first entering the password.
Pump Idle Time to System Inactive: The heating sys-
tem will be disabled after the pump has been idle for the
set amount of time
Power Type: Select the system power type.
Circuit Breaker Size: Select the circuit breaker size.
Refill Setting: To use the automatic vacuum transfer,
select Auto. To disable the automatic vacuum transfer,
select Manual. The main reason to disable automatic
refill is while flushing. However, if an issue is present
with the automatic refill system that cannot be solved in
a timely manner, manual refill can be used to return the
system to service. See Manual Refill on page 30.
See Select ADM Settings on page 24.
Appendix A - ADM
117