Appendix A - Adm; General Operation; Icon Identification - Graco 24T918 Instruction Manual

Appendix A - ADM

Appendix A - ADM

General Operation

ADM Power
The ADM automatically turns on when the main power
switch is turned ON.
Screen Navigation
To switch between the Setup and Operation screens,
press . Use ,
between screens.
Enable, Disable Heating System
To enable or disable the entire heating system,
press . To set which channels are active when the
heating system is enabled, use the System 2 screen.
See page 117.

Icon Identification

Icon Description
Operation Screens Only
Heating disabled
Warming up, actual tempera-
ture is below setting
Temperature setting achieved
Actual temperature of hose
(left) and applicator (right)
Actual temperature of system
(shown warming up)
System temperature setting.
Use
ting.
Use the physical numeric key-
pad on ADM to enter tempera-
ture setting.
114
, , and to navigate
and to adjust set-
Icon Description
Select channel to view and/or edit
the applicator or hose temperature
setting
Applicator temperature setting.
Use and
ting.
Hose temperature setting.
Use and
ting.
Use to adjust temperature settings
Temperature settings of applicator
(top) and hose (bottom)
Reset weight total
Setup Screens Only
Enter screen to change settings
Exit screen
Reset Maintenance error
Schedule Screen Only
Edit schedule value
Erase schedule value
Accept schedule change
Cancel schedule change
to adjust set-
to adjust set-
333347F