Installation; First Run; Restoring Default Parameters - EBS LX1NB-5L Installation And Programming Manual

2. INSTALLATION

CAUTION!
For the device to work properly, voice mail has to be disabled

2.1. FIRST RUN

CAUTION!
SIM Card has to be removed from the device before first run
Please switch the power supply off before following any of the below instructions.
Device can be configured either by using SMS commands or by provided Configuration
Tool:
 If you intend to use Configuration Tool, please connect the programming cable
and select the programming mode. Switch the power supply on. Please refer to
chapter 3.1 for further instructions.
 If you intend to configure the device by SMS Commands, please either set SIM
Card's PIN to "1111" or disable it. You can insert the SIM card into the SIM Card's
slot now. Switch the power supply on. Please refer to chapter 3.2 for further
instructions.

2.2. RESTORING DEFAULT PARAMETERS

You can restore default configuration by following these steps:
1. Turn off the power supply
2. Press and hold the PROG button
3. Turn on power supply – ST and OK LEDS should turn on
4. Wait for ST and OK LEDS to start flashing
5. Release PROG switch.
Default configuration has now been restored.
Restoring factory defaults configures the device as follows:
 Administrators are cleared
 Call back option is turned off
 "Allow any" option is turned off
 Periodic status info is turned off
 Account balance check code cleared
 Admin password reset to "0000"
 User's memory is NOT affected by this operation, to clear user's memory,
please refer to the DELETEALLUSERS command.
LX1NB-5L Short manual Page 9 / 24