General Information; Capabilities; Functionality; Relay Output - EBS LX1NB-5L Installation And Programming Manual

1. GENERAL INFORMATION

LX1NB-5L is a SMS/GPRS switch in an IP65 plastic enclosure for the control of gates, doors,
lighting, pumps, Generators, HVAC etc with CLIP or SMS.

1.1. CAPABILITIES

LX1NB-5L offers the control of a relay with NC and NO outputs. Up to 5 Administrators
and 500 Users can be configured.
The Transmitter offers:
 clip functionality
 callback option
 "allow all" option
 periodic status information messages
 account balance check

1.2. FUNCTIONALITY

Relay output

1.2.1.
The relay output can be activated either by a user's call or by an admin's SMS
command. It can be configured to activate for a set amount of timed or toggle mode.
Toggle mode means that the output state will change every time a user call is
detected.

Clip and callback

1.2.2.
The device will reject every call after 3 or 4 rings. If the calling number is authorized,
the relay will be activated. If a callback option is activated, LX will return a call to the
user.

Administrators

1.2.3.
Administrators can configure the device using SMS commands explained below.
They cannot activate the relay by CLIP unless they are programmed as a user, they
can activate the relay by sending an SMS command. Up to 5 administrators can be
programmed.

Users

1.2.4.
Users can call the device in order to activate the relay. Up to 500 users can be
programmed. A call from a non-users number will not activate the relay.
NOTE: It is possible to program the same phone number for both
administrators and users. In that case this number will be authorized to
perform actions available for both groups.
LX1NB-5L Short manual Page 4 / 24