EBS LX1NB-5L Installation And Programming Manual page 18

Configure system date and time
Command
Response
Single/Multiple
This command can be used to change current system date and time.
<YY> should be two last digits of year
<MM> should be the number of a month
<DD> should be the number of a day
<HH> should be the hour
<MM> should be the minutes
<SS> should be the seconds
Example: 1234 DT=15-01-10,12:50:10 will set date to 2015-01-10 and time to
12:50:10
Configure account balance check code
Command
Response
Single/Multiple
This command can be used to configure the account balance check code. This code is
mobile operator specific.
<code> should be the code that is used to check the account balance.
Example: 1234 CONFIGBALANCE=*103*# will set the account balance check code to
*103*#
Get account balance
Command
Response
Single/Multiple
This command can be used to check the current account balance. Please note, that
this command will forward the message from mobile operator. If for any reason, this
service is disabled for the currently used SIM card, this command might not work.
Example: 1234 GETBALANCE will start an account balance check procedure. The
device will dial the configured code (refer to CONFIGBALANCE) and return the
message from the network operator.
LX1NB-5L Short manual
DT=<YY>-<MM>-<DD>,<HH>:<MM>:<SS>
Date and time changed
SINGLE
CONFIGBALANCE=<code>
Code changed
or error message
SINGLE
GETBALANCE
Message from the mobile operator or error message
SINGLE
or error message
Page 18 / 24