EBS LX1NB-5L Installation And Programming Manual page 17

Configure periodic tests
Command
Response
Single/Multiple
This command can be used to configure the periodic tests with system status
information. These messages will be sent to all administrators.
System will send a text message with system status (same as response for
GETINFO), every <day period> days, exactly at <hour> o'clock.
<day period> should be any number greater than or equal to 0.
<hour> should be any number greater than or equal to 0 and less than 24.
If both <day period> and <hour> are equal to 0, periodic tests will not be active.
This option (if activated) will ensure the mobile operator will not deactivate the
prepaid SIM card.
Example:
1234 CONFIGTEST=1,15 will setup the device to send system status message every
day at 15 o'clock.
1234 CONFIGTEST=0,0 will deactivate the periodic system status messages
Get current system status
Command
Response
Single/Multiple
This command can be used to get information about current system status.
<strength> is GSM's signal strength, scaled from 0 to 7. If signal evaluation cannot
be currently performed due to network issues, <strength> will be presented as '?'.
<number of
<number of users> is number of currently programmed users.
Example:
1234 GETINFO will return system status
Set output state
Command
Response
Single/Multiple
This command can be used to activate or deactivate the relay output.
<ON/OFF> should be either ON or OFF word, depending on what output state one
wishes to force. In case of output activation, it will activate for a time set by the
CONFIGOUTPUT command.
Example:
1234 OUTPUT=ON will activate the output for the configured time (refer to
CONFIGOUTPUT command)
1234 OUTPUT=OFF will deactivate the output
LX1NB-5L Short manual
CONFIGTEST=<day period>,<hour>
Periodic tests configuration changed
SINGLE
GETINFO
SignalStrength: <strength>/7
AdminsCount: <number of administrators>
UsersCount: <number of users>
SINGLE
administrators
> is number of currently programmed administrators.
OUTPUT=<ON/OFF>
Output state updated
SINGLE
or error message
or error message
Page 17 / 24