Troubleshooting The Handheld Remote - MotorGuide Xi3 Wireless Edition Operation, Maintenance & Installation Manual

OWNER SERVICE ASSISTANCE
Symptom
Difficulty removing
propeller

Troubleshooting the Handheld Remote

ERASING THE RECEIVER'S MEMORY
Erasing the receiver's memory will erase all electronic ID numbers that are
stored in the receiver's memory.
1. Plug in the battery cable to a power source. In less than ten seconds,
press the left, propeller, and right buttons on the handheld remote
simultaneously.
2. Listen for a long beep indicating the receiver has erased all stored
electronic ID numbers.
NOTE: If the buttons on the remote are not pressed simultaneously within ten
seconds, or a long beep is not heard, unplug the battery cables from the
power source and then refer to Activating the Wireless Foot Pedal and
Activating the Handheld Remote
Battery Information
REPROGRAMMING THE REMOTE
NOTE: This activation procedure applies to the foot pedal and handheld
remote.
IMPORTANT: To activate multiple foot pedals or remotes, the motor must be
unplugged from the power source and then plugged back into the power source
between activating each control device.
1. Deploy the trolling motor.
2. Unplug the battery cables from the power source. Wait 30 seconds and
then reconnect the motor to the power source.
3. In less than ten seconds, press and hold the left arrow and right arrow
buttons simultaneously on the handheld remote. For the foot pedal
controller, hold the propeller and anchor button simultaneously.
HANDHELD REMOTE BATTERY REPLACEMENT
Battery required: One AAA alkaline battery
Possible Cause
Bent propeller pin
Bent armature
shaft
in the Product Installation, Wiring, and
section of this manual.
36
Resolution
Hold one blade and lightly tap the
opposite blade with a rubber
mallet.
Use a putty knife on both sides of
the propeller to apply equal
pressure.
Contact a Service Center.
eng