Table of Contents
Advertisement
Past Trip 3 — Past trip information or None.
Past Trip 4 — Past trip information or None.
Note:
An improper P9 ASD setup may cause some trips — reset the P9 ASD to the
Factory Default settings before pursuing a systemic malfunction (Program
Utilities Type Reset Reset to Factory Settings).
Direction — Displays the Direction command (forward/reverse).
Discrete Input Terminals — Displays the status (activated = reverse video) of the discrete input
terminals of the Terminal Board.
Discrete Output Terminals — Displays the status (activated = reverse video) of the discrete
output lines of the Terminal Board.
Output Frequency — Displays the running frequency
Main Monitor Selections
Two (2)
Monitor Mode
on the Frequency Command screen while the P9 ASD is running.
Note:
Virtual Linear Pump Average and Work Hours may also be selected as Main
Monitor items, but are not displayed at the Monitor screen.
The selected items, along with their real-time values, are displayed on the Frequency Command screen
while running. Not all Monitor Mode items are available for display on the Frequency Command
screen. The available items are underlined on
Any two of the underlined items may be selected from the listing at Program Utilities Main Monitor
Selections. Select an item from the Monitor 1 listing and another item from the Monitor 2 listing to be
displayed as shown in
P9 ASD Installation and Opeation Manual
items may be selected from the Main Monitor Selections screen to be displayed
pg. 45
Figure 22 on pg. 31
(DC Voltage and Output Current shown).
and
pg.
46.
47
Advertisement
Table of Contents
