Table of Contents
Advertisement
Figure 33. Complete the Virtual Linear Pump Setup.
14. Press the Stop key to complete
the setup.
15. Click Exit to save settings
(Exit becomes available at zero
Hz).
Figure 34. Run the Motor/Pump in the Direct Mode.
16. From the Frequency
Command screen, press ESC
and scroll to the Virtual Linear
Pump Control field. Select
Direct Mode if using no
feedback (if using feedback, go
to
17. While in the Hand mode, and
from the Frequency Command
screen, press Run.
18. During operation, adjust param-
eters
operation if unstable.
P9 ASD Installation and Operation Manual
Step 19. on pg.
76).
F500
and
F501
to stabilize
Press ESC
75
Advertisement
Table of Contents
