Wantegrity HAWK-800 Owner's Manual page 36

notes per bar. However, using 32 quarter notes per bar results in half the memory available for sequences.
2. There are now seven (7) sequencers available for editing and playback. Each sequence has record and playback
up to a maximum of 256 notes.
3. The HAWK-800 display now shows the current selected sequence (1 – 7) to the left of the Poly mode. In the
illustration below, sequence three (3) is shown as selected. You can select a sequence by pressing and holding
down the "Bank Hold" button and then pressing keypad numbers 1 through 7.
4. Once you have selected a sequence, you can enter sequence edit mode by pressing and holding down the
"Write" button and then pressing the sequencer "Start" button. The display will immediately switch into
sequence edit display mode. The illustration below shows the display as it would be if we had first selected
sequence three (as mentioned in point 3 above) and then pressed and held the "Write" button while then
pressing the sequencer "Start" button. The display shows the selected patch (which can be changed using the
up/down buttons). It also shows the selected sequence (3), the bar counter (shown as 1 since we are editing the
first bar) and also shows the ¼ note counter. In sequencer step edit mode, the display now shows a bar count (up
to 9 bars). If you edit beyond 9 bars then the bar display will change to a dash ("-") and it is up to you to count
bars beyond 9. The display also shows a quarter note counter up to a maximum of 64 quarter notes per bar. The
quarter note counter counts up to the maximum set by global parameter 43 and the resets back to one (1) when
entering into the next bar. This makes it much, much easier to determine (and therefore edit) the quarter note
position that you are editing in each bar.
Illustration 1: Advanced Sequence Mode Display
Illustration 2: Advanced Seq. Edit Display
-36-