P2 28 - Lfo2 Sync Driven Frequency; Dco Modulation Group; P2 31 - Dco Lfo Waveform Selector; P2 32 - Dco Lfo Modulation Source Selector - Wantegrity HAWK-800 Owner's Manual

P2 28 – LFO2 sync driven frequency
00-63 – 00=use normal clocking
01-63 set frequency to xx sequencer or MIDI ticks
Allows MIDI or on board sequencer clock to drive the frequency of LFO2.

DCO Modulation Group

The digitally controlled oscillators (DCO1 and DCO2) pitch (frequency) can now be modulated by any of the four LFO's and
the EG3 envelope generator. Modulation applies to both DCO1 and DCO2 so that they both modulate in identical ways.
This is because both DCO's operate using a single master oscillator.
P2 31 – DCO LFO waveform selector
1-11 – 1=triangle
2=inverted triangle
3=sawtooth
4=inverted sawtooth
5=sine wave
6=inverted sine wave
7=square PWM wave
8=inverted square PWM wave
9=random sample and hold from selected LFO
10=random sample and hold from sequencer clock or MIDI clock
11=random sample and hold from sequencer loop/repeat point
Selects the LFO waveform that will be used to modulate the DCO's.
P2 32 – DCO LFO modulation source selector
1-4 – 1=LFO1, 2=LFO2, 3=SLFO3, 4=SLFO4
Selects the LFO or SLFO that will modulate the DCO's.
P2 33 – DCO LFO modulation depth
00-15 – 00=no LFO modulation, 01-15 apply LFO modulation
Selects the amount of LFO modulation to apply to the DCO's. Setting this parameter to zero will turn off all LFO
modulation of the DCO's. Setting this parameter to 15 will apply the maximum possible modulation.
P2 35 – DCO EG invert
1-2 – 1=EG addition, 2=EG subtraction
Selects where the envelope generator modulation is added to or subtracted LFO DCO modulation. If no LFO modulation is
applied then the modulation applied by EG will be added or subtracted from the point of no modulation at all.
P2 36 – DCO EG depth
00-15 – 00=no EG modulation, 01-15 apply EG modulation
Selects the amount of EG modulation to apply to the DCO's. Setting this parameter to zero will turn off all EG modulation
-23-