P2 53 - Resonance Lfo Modulation Source Selector; P2 54 - Resonance Lfo Modulation Depth; P2 56 - Resonance Eg Depth; P2 57 - Resonance Eg Invert - Wantegrity HAWK-800 Owner's Manual

P2 53 – Resonance LFO modulation source selector
1-4 – 1=LFO1, 2=LFO2, 3=SLFO3, 4=SLFO4
Selects the LFO or SLFO that will modulate the resonance.
P2 54 – Resonance LFO modulation depth
00-15 – 00=no LFO modulation, 01-15 apply LFO modulation
Selects the amount of LFO modulation to apply to the resonance level. Setting this parameter to zero will turn off all LFO
modulation of resonance. Setting this parameter to 15 will apply the maximum possible modulation.
P2 56 – Resonance EG depth
00-15 – 00=no EG modulation, 01-15 apply EG modulation
Selects the amount of EG modulation to apply to the resonance level. Setting this parameter to zero will turn off all EG
modulation of resonance. Setting this parameter to 15 will apply the maximum possible modulation.
P2 57 – Resonance EG invert
1-2 – 1=EG addition, 2=EG subtraction
Selects where the envelope generator modulation is added to or subtracted LFO resonance modulation. If you wish to use
subtraction then it is recommended that you set the resonance set point to a high value. Use low values for addition.
P2 58 – Aggressive Resonance**
0-1 – 0=normal resonance, 1=set aggressive resonance (Moog Slayer)
** NOTE: Only available with the aTomaHawk-800 upgrade kit.
Selects the mode of operation of the resonance modulation. Setting this parameter to zero applies the normal amount of
modulation to the resonance level. Setting this value to one (1) with the aTomaHawk-800 kit fitted also will set very
aggressive resonance levels.
** CAUTION ** – Damage to speakers, amplifiers and other audio equipment can occur with aggressive resonance
enabled. We recommend the use of a compressor or other audio level limiting device before using this feature.
** WARNING ** – Be extremely careful when using headphones while using aggressive resonance mode. Use proper
precautions to avoid hearing damage. An audio compressor is recommended. Use of headphones should be avoided since
a compressor cannot be inserted into the audio path.

FM/Noise Modulation Group**

** NOTE: FM is only available with the aTomaHawk-800 upgrade kit.
The output of the DCO's can be routed to the VCF modulation point. This simulates or resembles a form of frequency
modulation. This modification is only available with the addition of the aTomaHawk-800 upgrade kit. This modification of
the Poly-800 is also known as the FM800 modification. The VCF filter can now be DCO signal modulated by any of the four
LFO's and the EG3 envelope generator.
Since this parameter group requires the aTomaHawk-800 kit, we have also implemented a mode parameter that allows
-26-