P1 88 - Vcf Velocity Shape; P2 Parameter Groups; Lfo1 And Lfo2 Group; P1 11, 21 - Lfo1, Lfo2 Frequency - Wantegrity HAWK-800 Owner's Manual

P1 88 – VCF Velocity Shape
1-6 – 1 = Linear
2 = Inverted linear
3 = S shape
4 = Inverted S shape
5 = Logarithmic
6 = Inverted Logarithmic
VCF Velocity shape determines both the shape and the inversion of the application of velocity to the VCF set point.

P2 Parameter Groups

The P2 parameters are divided up into groups in a similar way as the P1 parameter groups. There are eight groups as
follows:
9. 11-18 – LFO1 group
10. 21-28 – LFO2 group
11. 31-38 – DCO modulation group
12. 41-48 – VCF modulation group
13. 51-58 – Resonance modulation group
14. 61-68 – FM modulation group (AtomaHawk only)
15. 71-78 – SLFO group
16. 81-88 – Tremolo and special parameters group
The following sections discuss each of the groups.

LFO1 and LFO2 Group

There are now two LFO's available. These LFO's have new waveforms, delay controls and modulation techniques. Both
LFO's have seven identical parameter controls. The eighth parameter is unique between the two LFO's. We discuss each of
the common parameters together and then discuss the unique parameters separately.
P1 11, 21 – LFO1, LFO2 frequency
00-15 – sets the frequency of the LFO's. Zero is slowest.
NOTE: There may be times where you find that the frequency of LFO2 is much slower than you expect or it may not cycle
at all. In those cases you should check for the desired setting of extended parameter 28 (see below).
P2 12, 22 – LFO1, LFO2 delay timer
00-15 – sets the onset delay for the LFO's.
Zero provides no delay while 15 is the maximum. The behavior of the delay is determined by parameter 14 and 24.
P2 13, 23 – LFO1, LFO2 free running
0-1 – 0=reset the LFO on note on trigger. 1=LFO free running
Allows the LFO's to operate independently of note trigger events. The LFO's never restart their waveform cycles when set
to free running. A note down event will restart the LFO cycle when this parameter is set to zero.
-21-