P2 77 - Slfo4 Free Running; P2 78 - Sustain Pedal Decay/Sustain Offset; Tremolo And Special Parameters Group; P2 81 - Tremolo Dco1 Mode And Lfo Source - Wantegrity HAWK-800 Owner's Manual

the midpoint).
P2 77 – SLFO4 free running
0-1 – 0=reset SLFO4 on note on trigger. 1=SLFO4 free running
Allows the SLFO4 oscillator to cycle without being reset be any note down event.
P2 78 – Sustain Pedal Decay/Sustain Offset
00-31 – 00=no decay or sustain offset, 01-31 increased decay and sustain.
This parameter allows the decay and sustain times to be increased from their settings in both EG1 and EG2 when the
sustain pedal is depressed. This allows realistic sustain pedal operation by allowing decay and or sustain to be extended
when the sustain pedal is being used.
NOTE: See Global parameter 17 for details on the three different sustain modes that are available.
NOTE: Using the sustain pedal cancels out the influence of the two velocity operators OP1 and OP2 (see P1 parameters 81-
86).

Tremolo and Special Parameters Group

This parameter group is split into two sub groups. The first four parameters are for control of tremolo and then last four a
unique per patch parameters.
P2 81 – Tremolo DCO1 mode and LFO source
0-2 – 0=set tremolo on DCO1 off
1=use LFO1 as source for tremolo modulation
2=use LFO2 as source for tremolo modulation
Use this parameter to disable tremolo on DCO1 or select LFO1 or LFO2 as sources for tremolo. The waveform used by
tremolo is always triangle.
P2 82 – Tremolo DCO1 LFO modulation depth
00-15 – 00=off, 01-15 sets tremolo depth on DCO1
Sets the depth of the tremolo. When you wish to apply the largest tremolo it is best to set the DCO1 volume (parameter
17) to 17 (the volume midpoint). This allows the maximum amount of tremolo depth (15) to be applied.
P2 83 – Tremolo DCO2 mode and LFO source
0-2 – 0=set tremolo on DCO2 off
1=use LFO1 as source for tremolo modulation
2=use LFO2 as source for tremolo modulation
Use this parameter to disable tremolo on DCO2 or select LFO1 or LFO2 as sources for tremolo. The waveform used by
tremolo is always triangle. When in double mode, DCO2 is modulated using the same DCO1 settings as set by P2
parameters 81 and 82 above.
P2 84 – Tremolo DCO2 LFO modulation depth
00-15 – 00=off, 01-15 sets tremolo depth on DCO2
-29-