P1 Parameters 11-18, 21-27; P1 13,23 - Dco Harmonics Selector; P1 14,24 - Dco Harmonics Modulation Waveform Selector - Wantegrity HAWK-800 Owner's Manual

8. 81-88 – Velocity sensitivity group
The following sections discuss each of the groups.

P1 Parameters 11-18, 21-27

Parameters 11 (DCO1 octave) and 12 (DCO1 waveform) and the DCO2 equivalents (21 and 22) have not changed. Also,
parameters 17 and 27 (DCO level) and 18 (DCO mode) have not changed. Refer to the original Poly-800 owners manual for
information regarding the use and setting of these parameters. Parameters 13 to 16 and 23 to 26 have changed and are
described below
P1 13,23 – DCO harmonics selector
1-16 – 1= 16'
2= 8'
3= 4'
4= 2'
5= 16' + 8'
6= 16' + 4'
7= 16' + 2'
8= 8' + 4'
9= 8' + 2'
10 = 4' + 2'
11= 16' + 8' + 4'
12= 16' + 8' + 2'
13= 16' + 4' + 2'
14= 8' + 4' + 2'
15= all harmonics on
16= all harmonics off
Selects the DCO harmonics to be enabled at note onset. If no harmonic modulation is applied then this parameter
determines the DCO harmonics that will be applied through the entire duration of a played note. If harmonic modulation
is applied then this parameter determines the harmonics that will sound at initial note onset only.
P1 14,24 – DCO harmonics modulation waveform selector
1-11 – 1=triangle
2=inverted triangle
3=sawtooth
4=inverted sawtooth
5=sine wave
6=inverted sine wave
7=square PWM wave
8=inverted square PWM wave
9=random sample and hold from selected LFO
10=random sample and hold from sequencer clock or MIDI clock
11=random sample and hold from sequencer loop/repeat point
Selects the LFO waveform that will be used to modulate the DCO harmonics.
-17-