Tools Function 1 - Display Software Versions; Tools Function 2 - Validate Patch Memory; Tools Function 3 - Clear Global Memory; Tools Function 4 - System Memory Inspection - Wantegrity HAWK-800 Owner's Manual

"Good" if the command executed correctly. Press the "Write" button to return back to "Tools" display where you can
execute another utility tool command.
There are two ways to exit tools mode. Pressing the "Bank Hold" button will return you to normal synthesizer operation.
Or, you can press the "Prog/Para" button and the synthesizer will reboot and will go through normal start up procedure
until it enters normal operation.

Tools Function 1 - Display Software Versions

Press "1" and tools mode will display the software version installed in the boot ROM. After approximately two seconds,
the display changes to show the software version that is installed in the flash software memory. After approximately two
seconds, the display will change to "Good". Press the write button to continue back into Tools mode or press

Tools Function 2 - Validate Patch Memory

Press "2" and the tools mode will ensure that all patch data is within parameter value limits. If any data is found to be
outside of correct limits then that parameter value will be set to half of the possible maximum.

Tools Function 3 - Clear Global Memory

Press "3" and the tools mode will reset all global memory to zero except for the device type (global parameter 34) which
will retain its value. It is important to ensure that the device type and all other parameters are set correctly. Use this
function with care.

Tools Function 4 - System Memory Inspection

Press "4" and the display will change to show data stored in system memory. The address pointer uses the four left hand
displays. Pressing keypad numbers changes the address pointer in 8K blocks . The Up and Down buttons scroll through
addresses. And the two right hand seven segment displays show the data stored in the memory location.
Tools Function 7 – Patch Bank Dump to System Exclusive Message
Press "7" and the HAWK-800 will send a system exclusive message out the MIDI OUT port that is a HAWK bulk patch
dump. This sysex message contains a copy of all of the 64 patches found in the currently selected patch bank (as
determined by global parameter 13). To use this tool function you should set up your MIDI computer or another HAWK-
800 to receive the patch dump from the HAWK-800 MIDI out port. If you intend to send the patch flash dump to another
HAWK-800, you would set up the receiving unit in tools mode "8" (see below for details) and then engage tools mode "7"
Keypad Inspection Memory Address
1
2
3
4
5
6
7
8
-33-
0x2000
0x4000
0x6000
0x8000
0xA000
0xC000
0xE000
0x0000