P2 61 - Fm800 Set Point; P2 62 - Fm800 Lfo Modulation Waveform Selector; P2 63 - Fm800 Lfo Modulation Source Selector; P2 64 - Fm800 Lfo Modulation Depth - Wantegrity HAWK-800 Owner's Manual

the noise generator level to be modulated by this parameter group.
P2 61 – FM800 set point**
00-99 – 00-99 set the FM800 level
Use this parameter to set the FM800 level from zero to maximum (99).
P2 62 – FM800 LFO modulation waveform selector**
1-8 – 1=triangle
2=inverted triangle
3=sawtooth
4=inverted sawtooth
5=sine wave
6=inverted sine wave
7=square PWM wave
8=inverted square PWM wave
9=random sample and hold
Selects the LFO waveform that will be used to modulate FM800.
P2 63 – FM800 LFO modulation source selector**
1-4 – 1=LFO1, 2=LFO2, 3=SLFO3, 4=SLFO4
Selects the LFO or SLFO that will modulate the FM800.
P2 64 – FM800 LFO modulation depth**
00-15 – 00=no LFO modulation, 01-15 apply LFO modulation
Selects the amount of LFO modulation to apply to the FM800 level. Setting this parameter to zero will turn off all LFO
modulation of FM800. Setting this parameter to 15 will apply the maximum possible modulation.
P2 66 – FM800 EG depth**
00-15 – 00=no EG modulation, 01-15 apply EG modulation
Selects the amount of EG modulation to apply to the FM800 level. Setting this parameter to zero will turn off all EG
modulation of FM800. Setting this parameter to 15 will apply the maximum possible modulation.
P2 67 – FM800 EG invert**
1-2 – 1=EG addition, 2=EG subtraction
Selects where the envelope generator modulation is added to or subtracted LFO resonance modulation. If you wish to use
subtraction then it is recommended that you set the FM800 set point to a high value. Use low values for addition.
P2 68 – FM800 Mode**
0-2 – 0=Use the FM800 parameter group to modulate FM800 only.
1=Use the FM800 parameter group to modulate FM800 and noise level.
2=Use the FM800 parameter group to modulate noise level only.
-27-