P1 43 - Vcf Eg3 Polarity; P1 44 - Vcf Eg3 Intensity; P1 45 - Eg3 Trigger; P1 46 - Mk2 Bass Equalization - Wantegrity HAWK-800 Owner's Manual

It is important to understand that keyboard tracking is OFF when velocity sensitive VCF is enabled. Refer to P1 parameters
87 and 88 for additional detail.
P1 43 – VCF EG3 Polarity
1-2 – 1=normal positive polarity
2=negative polarity
P1 44 – VCF EG3 Intensity
0-15 – 0= EG3 influence off, 1=minimum – 15=maximum.
This parameter determines the amount of influence envelope generator 3 (EG3) will have over the VCF cut off.
P1 45 – EG3 Trigger
0-1 – 0= single trigger
1=multi triggering
This parameter determines if the envelope generator 3 (EG3) will be re-triggered by multiple notes (when set to 1) or if it
will only trigger once for the first note held down (when set to 0).
P1 46 – MK2 Bass Equalization
0-11 – 0 – 6 = lower bass
7 = neutral bass position
8 – 12 = higher bass
When the Poly-800 device global parameter (34) is set to 2 then these parameters become active. If global parameter 34 is
set to 0 or 1 corresponding with Poly-800 MK1 or EX-800 then parameters 46 and 47 are inactive and will not be available
for editing.
P1 47 – MK2 Treble Equalization
0-11 – 0 – 6 = lower treble
7 = neutral treble position
8 – 12 = higher treble
When the Poly-800 device global parameter (34) is set to 2 then these parameters become active. If global parameter 34 is
set to 0 or 1 corresponding with Poly-800 MK1 or EX-800 then parameters 46 and 47 are inactive and will not be available
for editing.
P1 48 – MK1 and EX-800 Chorus Effect
0-1 – 0 = chorus off
1 = chorus on
When the Poly-800 device global parameter (34) is set to 0 (MK1) or 1 (EX-800) then these parameters become active. If
global parameter 34 is set to 2 corresponding with a Poly-800 MK2 then parameter 48 will be inactive and will not be
available for editing.
-19-