Gl Xx - Cascading Sync Mode; Gl Xx - Device Type; Gl Xx - Keyboard Midi Transmit Note Octave Offset; Gl Xx - Keyboard Midi Transmit Note Velocity Offset - Wantegrity HAWK-800 Owner's Manual

both units be set to receive MIDI on the same channel.

33 GL xx - Cascading sync mode

xx – 0=off, 1=temporary on, 2=permanent on
If cascading synchronization mode is on then when program changes are made via the front panel a corresponding sysex
single patch send occurs so that a cascaded Poly-800 or EX-800 unit will update is corresponding patch so that it plays the
exact same sound as the master unit. When entering chord made, the Poly-800 will also send the chord progression that
has been set up so that the slave unit can play the same chord progression. This mode will generally be used when global
parameter 32 is also set on. Since it may not be expected that the synth would be sending patch dumps via MIDI at power
up, using mode 1 is recommended since on power up the synth will return to 0 sync mode. But if the owner wishes to
force sync mode on after power on then select mode 2.

34 GL xx - Device type

xx - 0=Poly-800 MK1, 1=EX800, 2=Poly-800 MK2
This parameter must be set according to the type of Poly-800 unit that the HAWK-800 kit is installed in. For the Poly-800
MK1 this parameter should be set to zero. For the EX-800 this parameter should be set to one. In the case of the EX-800,
pitch bend control messages and the pitch of the unit itself will not work correctly if this parameter is not set to one. If
your HAWK-800 kit is installed in a Poly-800 MK2 then the device type should be set to 2. This enables the MK2 effects
parameters (34-38 and 46-47) and disables parameter 48 (chorus).

35 GL xx - Keyboard MIDI transmit note octave offset

xx - 0=standard Poly-800 keyboard operation
1=down one octave
2=down two octaves
3=down three octaves
4=up one octave
5=up two octaves
6=up three octaves
Allows a Poly-800 keyboard to transmit MIDI note messages offset from their standard note configuration. This is useful
when you wish to use the Poly-800 as a MIDI controller because you can set the keyboard to transmit notes across the full
MIDI playable note range.

36 GL xx - Keyboard MIDI transmit note velocity offset

xx – 0-63
This parameter allows you to set the keyboard MIDI note velocity transmission level. The range for the parameter is 0-63
which corresponds with a MIDI note velocity range of 2 to 126.

37 GL xx - Sequencer note follow mode

xx - 0=off, 1=keyboard, 2=keyboard and MIDI operation
When the sequencer is playing, it is possible to have the sequencer shift keys within a one octave range to match the last
note played on the keyboard (or received from MIDI). This feature only applies to notes played on the lowest octave of the
keyboard. All notes played above the lowest keyboard do not change the sequencer key.
-13-