P1 15,25 - Dco Harmonics Modulation Lfo Selector; P1 16,26 - Dco Harmonics Modulation Depth; Mk2 Effects Unit Group; P1 34 - Mk2 Effects Unit Delay Time - Wantegrity HAWK-800 Owner's Manual

P1 15,25 – DCO harmonics modulation LFO selector
1-4 – 1=LFO1, 2=LFO2, 3=SLFO3, 4=SLFO4
Selects the LFO or SLFO that will modulate the DCO harmonics.
P1 16,26 – DCO harmonics modulation depth
00-15 – 00=no harmonics modulation, 01-15 apply LFO harmonics modulation
Selects the amount of LFO modulation to apply to the DCO's. Setting this parameter to zero will turn off all LFO
modulation of the DCO harmonics. Setting this parameter to 15 will apply the maximum range of possible modulation.

MK2 Effects Unit Group

The Poly-800 MK2 effects unit control parameters now reside at P1 parameter location numbers 34 through to 38. When
the Poly-800 device global parameter (34) is set to 2 then these parameters become active. If global parameter 34 is set to
0 or 1 corresponding with Poly-800 MK1 or EX-800 then these parameters are inactive and will not be available for editing.
P1 34 – MK2 Effects Unit Delay Time
00-99 – sets the delay of the MK2 effects unit.
P1 35 – MK2 Effects Unit Feedback
00-15 – sets the amount of feedback (echo) of the MK2 effects unit.
P1 36 – MK2 Effects Unit Modulation Frequency
00-31 – sets the modulation frequency that will be used to apply to the MK2 effects unit.
P1 37 – MK2 Effects Unit Modulation Intensity
00-31 – sets the amount of modulation intensity to apply to the MK2 effects unit.
P1 38 – MK2 Effects Unit Volume Level
00-15 – sets the volume level of the MK2 effects unit.

VCF Group

The Voltage Controlled Low Pass filters parametes reside at P1 parameter location numbers 41 through to 45.
P1 41 – VCF Cut Off Set Point
00-99 – sets the VCF cut off frequency.
P1 42 – VCF Keyboard Tracking
0-21 – 0= tracking off
1=half tracking
2=full tracking
-18-