Table of Contents
Advertisement
of the DCO's. Setting this parameter to 15 will apply the maximum possible modulation.
P2 38 – DCO Modulation mode
0-2 –
0=apply normal DCO modulation
1=apply pitch bend DCO modulation
2=not yet implemented (note biased pitch bend modulation)
Selects the mode of operation of the DCO modulation. Setting this parameter to zero applies the normal amount of
modulation to the DCO's such that they can modulate only one semitone up or down from the base note frequency.
Setting this parameter to one (1) will switch off pitch bend operation (for example: the joystick pitch bend will be disabled)
so that the modulation can move seven full notes up or down from the base note frequency. This allows much wider
frequency modulation by the LFO's or envelope generators.
VCF Modulation Group
The voltage controlled filter can now be modulated by any of the four LFO's and the EG3 envelope generator.
P2 41 – VCF 1
st
LFO waveform selector
1-8 –
1=triangle
2=inverted triangle
3=sawtooth
4=inverted sawtooth
5=sine wave
6=inverted sine wave
7=square PWM wave
8=inverted square PWM wave
9=random sample and hold from selected LFO
10=random sample and hold from sequencer clock or MIDI clock
11=random sample and hold from sequencer loop/repeat point
Selects the LFO waveform that will be used to modulate the VCF.
P2 42 – VCF 1
st
LFO modulation source selector
1-4 – 1=LFO1, 2=LFO2, 3=SLFO3, 4=SLFO4
Selects the LFO or SLFO that will modulate the VCF.
P2 43 – VCF 1
st
LFO modulation depth
00-15 – 00=no LFO modulation, 01-15 apply LFO modulation
Selects the amount of LFO modulation to apply to the VCF. Setting this parameter to zero will turn off all LFO modulation
of the VCF. Setting this parameter to 15 will apply the maximum possible modulation.
P2 44 – VCF 2
nd
LFO waveform selector
1-8 –
1=triangle
2=inverted triangle
3=sawtooth
4=inverted sawtooth
5=sine wave
-24-
- Quick Links:
- Global Parameter Editing Mode
Hide quick links:
Advertisement
Table of Contents
