Installation (Mechanical); Preliminary Checks; Material Admittance; Identification - Liebert Hinet 10kVA User Manual

Hinet UPS User Manual

2 Installation (Mechanical)

2.1

Preliminary Checks

Before installing the UPS hardware the following preliminary checks must be carried out:
1. Verify that the UPS room satisfies the environmental conditions stipulated in the equipment specification, paying
particular attention to the ambient temperature and air exchange system.
2.1.1

Material admittance

1. Remove any packaging debris, then visually examine the UPS and battery equipment for transit damage, both
internally and externally. Report any such damage to the shipper immediately.
2. Afterwards ascertain that the material supplied is as that reported on the freight bill.
2.1.2

Identification

The equipment supplied is provided with an adhesive identification label placed on the UPS rear panel reporting type of
UPS model and power.
The cases utilised to transport the equipment must be unpacked as specified by the procedure stated below.
2.1.3

Packing material removal

During this operation observe the indications (FRAGILE, UP) printed on the case to avoid damaging the UPS Hinet.
To remove the packing material proceed in the following manner:
- Place the equipment on the floor as instructed on the outer case (UP, DOWN).
- Use the extractor to remove the top of the crate .
- Remove the extruded elements utilised as packing protection.
- Use the extractor to remove all lateral sides of the crate
- Slide the forks of the lift truck under the UPS and after having lifted it a few centimeters from the floor, back up and
lay it down.
Hinet is provided with wheels to easily move it around.
- Do not throw away the packing material it might be used again to repack the equipment if having to send it back or to
send it to maintenance centres or for removal purposes.
- Check that the equipment has not been damaged. If otherwise immediately contact the Sales Representative.
2.1.4

Moving the cabinets

Ensure that any lifting equipment used for moving the UPS cabinet has sufficient lifting capacity.
ENSURE THAT THE UPS WEIGHT IS WITHIN THE DESIGNATED WEIGHT LOADING (KG) OF ANY
HANDLING EQUIPMENT. SEE THE UPS SPECIFICATION FOR WEIGHT DETAILS.
The UPS can be lifted using a fork lift. Take care when using either method not to damage the UPS castors located on
the bottom of the unit.
2.1.5

Placing it in the operative position

The UPS cabinets are fitted with castors on the base to allow ease of movement and positioning.
Castors are of sufficient strength for movement across even surfaces only. Castor failure could occur if subjected to
shock loading
When the equipment has been finally positioned ensure the adjustable feet are set so that the UPS will remain stationary
and stable
The place chosen must guarantee:
- easy connection;
WARNING
WARNING
(12/01)
Page 5