Swing Setting - Sinclair SWC-02 User Manual

3.6 Swing Setting

In unit on status, press SWING button for swing setting. Two swing modes are
available: fixed-angle swing and simple swing.
When fixed-angle swing mode is set, swing operation is as follows:
In unit on status, press SWING button to select up&down swing
swing angle will be adjusted circularly as below:
→ → →
Select up&down swing and left&right swing through "＜" or "＞" button. When
left&right swing
below:
→ →
Note:
Turn on fixed-angle swing mode in function setting page;
① .
If fixed-angle swing is not available for the model, fixed-angle swing will be
② .
invalid when the wired controller turns on fixed-angle swing mode.
Simple swing mode: when fixed-angle swing mode is turned off, swing operation is
as below:
Pressing SWING button under unit on status, up&down swing frame occurs. Then
press SWING button to turn on or turn off up&down swing.
up&down swing is on and is not displayed when up&down swing is off. When up&down
swing frame have not disappeared, press "＜" or "＞" button to switch to left&right swing
setting. Then left&right swing frame occurs. In this case, press SWING button to turn on
or turn off left&right swing.
displayed when left&right swing is off. For detailed operation, please refer to Fig. 7.
→ → → closed →
is selected. Left&right swing angle will be adjusted circularly as
→ → →
is displayed when left&right swing is on and is not
→ closed→
6
. Up&down
is displayed when