Canon iRC2100 Getting Started page 47

31 Setting up PostScript printing in Windows NT 4.0 and/or Windows 2000
4. Enter the IP address of the iR C2100/2100S.
If your network uses Domain Name Services (DNS), enter the DNS name
assigned to the iR C2100/2100S instead of the IP address.
5. Press Tab and type one of the following names, depending on the
iR C2100/2100S connection you would like to print to.
print
hold
This name is case-sensitive; type it exactly as shown above.
N :
OTE
6. Click OK.
The workstation checks the address or DNS name you entered and notifies
you if it cannot resolve the address.
7. Click Close in the Printer Ports dialog box.
The new port configuration is reflected in the Ports tab. You must now close
the Printer Properties dialog box to verify the connection.
8. Click OK to close the Printer Properties dialog box.
9. Reopen the Printer Properties dialog box.
10. Click the General tab and click Print Test Page.
When you print, your PostScript files are transmitted over the LPR Port
connection to the iR C2100/2100S.
11. Click OK to close the Printer Properties dialog box.
Completing the Windows 2000 TCP/IP and LPR connection
Once you have installed the PostScript printer driver and printer driver files,
complete the setup for the TCP/IP and LPR connection as follows:
• Prepare the iR C2100/2100S to accept print jobs using TCP/IP and LPR
protocols. (For details, see the Configuration Guide.)
• Enable LPD or Port 9100 from the iR C2100/2100S Control Panel.
(For details, see the Configuration Guide.)
• Configure the workstation for the TCP/IP connection.