Installing/Removing Headstock Center - Grizzly G0799 Owner's Manual

Headstock Center
Installing/Removing
Headstock Center
The included spur center installs in the headstock
spindle with an MT#2 tapered fit.
Installing Headstock Center
1. DISCONNECT MACHINE FROM POWER!
2. Make sure mating surfaces of center and
spindle are free of debris and oily substances
before inserting center to ensure a good fit
and reduce runout.
3.
Insert tapered end of center into spindle, and
push it in with a quick, firm motion, as shown
in Figure 32.
Figure 32. Installing center in headstock spindle.
4. Make sure center is securely installed by
attempting to pull it out by hand—a properly
installed center will not pull out easily.
-32-
Removing Headstock Center
1.
DISCONNECT MACHINE FROM POWER!
2.
Hold a clean rag under spindle or wear leath-
er glove to catch center when you remove it.
3.
Insert knockout tool through outbound end of
spindle and firmly tap back of center, catch-
ing it as it falls, as shown in Figure 33.
Knockout Tool
Figure 33. Removing headstock center with
knock-out tool.
Model G0799 G0800 (Mfd. Since 09/15)