Outboard Tool Rest; Installing/Removing Headstock Center - Grizzly G0694 Owner's Manual

Outboard Tool Rest

When the workpiece is larger than 20" in diam-
eter, mount the workpiece on the outboard side of
the lathe and use the outboard tool rest.
To use the outboard tool rest:
1. While firmly holding the tool rest support rod,
loosen the lock levers shown in Figure 16.
Tool Rest
Lock
Levers
Figure 16. Outboard tool rest assembly.
2. Adjust the tool rest support rod so that it rests
firmly on the floor.
3. Adjust the position and height of the tool rest
for your operation.
Note: As with the inboard tool rest, make sure
the outboard tool rest is approximately
away from the workpiece and approximately
⁄ " above the workpiece center line.
1
8
4.
Firmly re-tighten all lock levers before starting
the operation.
-22-
Installing/Removing
Headstock Center
The included spur center installs into the head-
stock spindle with an MT#2 tapered fit.
Installing Headstock Center
1.
2.
3.
Lock
Levers
Tool Rest
Support
Rod
Figure 17. Installing center into the headstock
⁄ "
1
4
4.
DISCONNECT MACHINE FROM POWER!
Make sure the mating surfaces of the center
and spindle are free of debris and oily sub-
stances before inserting the center.
Insert the tapered end of the center into
the spindle, and push it in with a quick, firm
motion (see Figure 17).
Spur Center
spindle.
Make sure the center is securely installed by
attempting to pull it out by hand—a properly
installed center will not pull out easily.
Model G0694 (Mfd. Since 03/15)